Anti-Seep collars are user friendly and can be installed during new pipe installation or around an existing pipe.
- Help prevent your pipe from being washed out.
- Constructed from durable 1/4" high density polyethylene plastic (HDPE)
- Pre-cut and drilled with stainless steel bolts and bands.
- Tools needed to assemble: Two small wrenches and a screwdriver.
- Available for Corrugated Plastic, PVC and Steel Pipe
- Available in 4' x 4', 5' x 5' and 6' x 6' sizes.
- Pipe Type and OD - Outside Diameter required
- Shipping is included in the 48 contiguous states
NOTE: Actual size not shown. Picture is a 6' x 6' x 10". The flat surface of the Anti-Seep is reduced as the diameter of the pipe increases.
For example:
A 4' x 4' x 12" - approximately 17" +/- of flat surface on each side.
A 4' x 4' x 18" - approximately 14" +/- of flat surface on each side.
Installation Instructions:
- Apply tar or mastic to bottom half of collar and lay pipe on collar.
-
Apply mastic to top half of collar and set in place lining up red stripes.
-
Bolt two halves together.
- Install metal bands on split halves of collar.
- Tighten bolts and bands.
-
Apply mastic as needed for a good seal.
- Backfill and hand tamp.