Low Profile Septic Chambers

LOW PROFILE SEPTIC CHAMBERS

Low Profile Septic Chambers

Infiltrator brand chambers can be used in almost any septic leachfield application.

Wherever pipe and stone can be installed, Infiltrator chambers can be used. This includes trench, bed, and elevated mound installations. Infiltrator chambers provide superior treatment capabilities in pressure dosing, level distribution, evapotranspirations, and sand filter applications.

The Quick4 Plus™ Standard Low Profile chamber offers maximum strength through its four center structural columns.

This chamber can be installed in a 36" wide trench. It is shorter in height than Infiltrator’s other Standard model chambers, allowing for shallow installation. Like the original line of Quick4® chambers, it offers advanced contouring capability with its Contour Swivel Connection™, which permits turns up to 10°, right or left.

Benefits:

Low profile design makes this chamber ideal for shallow applications
Reduces imported fill needed for cap and fill systems
Advanced contouring connections
Latching mechanism allows for quick installation
Four-foot chamber lengths are easy to handle and install
Supports wheel loads of 16,000 lbs./axle with 12" of cover

INFILTRATOR CHAMBERS & THEIR ACCESSORIES ARE IN STOCK!

VISIT OUR WEBSITE AT
https://www.drainagesolutionsinc.com/product_list.php?category_id=351

OR CALL 317-346-4110 TO LEARN MORE.

PLEASE NOTE: Many installation requirements and options are governed by local codes instituted by the health department in your area. When in question, check with the local health department for specifics and follow their code instructions.

Sure-Loc Steel Edging offers your landscape design a permanent solution to edge control.

Grundfos Submersible Well Pump

With motor protection and wear-reducing benefits.

Grundfos SQ 3" submersible pump

At only 3” in diameter, the Grundfos SQ submersible pump is extremely compact and ideal for small or restricted boreholes. In addition to the features and benefits shared with the renowned SP submersible pump, the SQ offers a number of motor protection and wear-reducing features that makes it the obvious choice for groundwater extraction at domestic or small waterworks, for irrigation systems, or for groundwater lowering.

HOW THE SQ PROTECTS AND REDUCES WEAR VOLTAGE HANDLING

Increased winding temperature caused by undervoltage often results in reduced lifetime. The SQ motor is protected against over and undervoltage, and voltage fluctuation in general.

SOFT START

Soft start ensures a low starting current with a smooth and steady acceleration. This offers excellent starting reliability at low voltage, prevents overload of the mains power, reduces water hammer in the pipe, and reduces pump wear. Low current draw and soft start allows use of smaller gauge wire compared to traditional 4” motors. This can reduce the overall cost of installation.

POWER SUPPLY

Low ampere usage makes it possible to connect more appliances to the same fuse group or reduce the size of the power line. Small generators can be used with SQ. Grundfos recommends the use of a generator with a capacity 50% higher than rated pump power consumption.

DRY RUNNING PROTECTION

The SQ pump is factory pre-set based on minimum power consumption, and dry-running protection is activated 40 seconds after power is connected to allow priming of the pump. When there is no water in the hydraulics, power consumption is reduced. The SQ stops automatically when below the dry run power limit and restarts automatically within 5 minutes after cut-out.

APPLICATIONS:
Grundfos SQ 3" submersible pumps are suitable for both continuous and intermittent operation for a variety of applications:

Ground water supply – private housing, small waterworks, small irrigation systems
Liquid transfer in tanks
Pressure boosting
Environmental applications – remedial pumping or sampling

DELIVER POWERFUL, RELIABLE OPERATION WITH GRUNDFOS 3” SQ SUBMERSIBLE PUMP

A lightweight, reliable pump with 20 year performance record
Easily installed in a 4” well that will no longer accommodate a 4” nominal O.D. pump
Built in soft start, dry run protection and over/under voltage protection
Broadest operational voltage range (150 to 280) in the industry - reducing call backs
Operates like a conventional 2 wire pump

WE STOCK ½ HP 115 VOLT and 230 VOLT MODELS OF 10SQ05-160/230 at DRAINAGE SOLUTIONS, INC.

Questions? Ask Joey at our Greenfield, Indiana location.
Call (317) 894-2210 or e-mail jcollins@drainagesolutionsinc.com.

SHARE WITH US!

We'd love to see pictures from your latest project!

Send us high resolution photos from a site on which you used products purchased from Drainage Solutions, Inc.

YOUR photos may be featured in a future article for our e-newsletter or in a post on Social Media!

Here’s the e-mail address: sharewithus@drainagesolutionsinc.com.

Thanks, and good luck!

Accessories
Catch Basins & Grates
Channel & Trench Drain
Drainage Accessories
Fittings & Valves

Erosion & Sediment Control
Landscape Supplies
Pipe
Septic
Tools

Customer Login

Low Profile Septic Chambers

LOW PROFILE SEPTIC CHAMBERS

Low Profile Septic Chambers

Grundfos Submersible Well Pump

Ask An Experts

Subscribe To Our Newsletter