click to zoom in

Reed HPC4+ Guillotine Pipe Cutter for PE 04605

No reviews yet Write a Review
Usually Ships in 24 Hours
Proposition 65:
WARNING Cancer and Reproductive Harm -

Reed HPC4+ Guillotine Pipe Cutter for PE 04605


Robust Guillotine Pipe Cutters are designed to cut PE pipe from SDR15.5 to SDR9.

  • Cuts PE up to 4" (125 mm).
  • New all aluminum construction results in lighter weight and greater rigidity
  • Greater capacity, up to 4.9 in O.D.   Slightly enlarged pipe capacity fits true 4 in DIPS and IPS for PE
  • Aluminum rails and crosshead have a hard anodize finish to reduce wear on sliding surfaces
  • Superior cuts with MADE IN USA blade
  • Squarest cut available, within 1⁄8" (3 mm) on medium and high density pipe, due to strong frames and unique blade design.
  • Saves facing cost: no facing needed for electrofusion, less needed for butt-fusion.
  • Requires minimal clearance, only 4" – 6" (102 - 152 mm) around pipe.
  • Clean and safe! No chips to clog valves and apertures.
  • Many high quality cuts, with durable non-stick coated (resharpenable and replaceable) tool steel blade.
  • Replacement Blades
  • Application: PE
  • SDR 15.5 - SDR9
  • Pipe Capacity: 2 in O.D. minimum 4.9 in O.D. maximum  (48 – 125 mm O.D.)
  • Pipe Range:  1 ½ in IPS – 4 in DIPS for SDR15.5 ‐ SDR9
  • Length: 19"


HPCs cut PE only and will not cut PVC or PP (polypropylene) pipe, such as Aquatherm®.

Temperature impacts pipe density. Cold temperatures (below freezing) can significantly shorten blade life.

Blade is very sharp. Take care when reaching in that area.

For operator and blade safety, always transport the cutter with the blade fully seated in the base of the cutter. Use the blade guard if available since it protects the blade and the operator.

Reed strongly recommends use of the PEGR7 Static Grounding Device (#04621) with Guillotine Cutters. Use a grounding device as a precaution against static build-up. Dissipate the charge and minimize the possibility of ignition.