Channel & Trench Drain

Grate Cover Tape is ideal for keeping the grates clean during installation. 5 1/4" x 100'> Available in 200 ft. rolls

PolyClips are installed at the channel joints. Height adjustment is made by loosening the clamp bolt and sliding base brackets up or down on the rebar legs. Lateral and longitudinal adjustment plus retention are made by positioning and tightening...

ABT Polydrain PolyClip was developed to speed channel installation and make the joining of the channels more secure before the pour. PolyClip consists of: two special securing brackets (one for either side of the channel); a “no-float” U-shaped leg that...

A flexible one-part polyurethane in a standard caulk tube, used as a general purpose sealant for gray water applications. 11 oz. Tube Call for information on PolySeal 4 - Zpolyester (Part Epoxy)

Vertical outlet plates fit over the cutouts on each of the outlet channels. 8 in. and 12 in. outlets are also available.

Vertical outlet plates fit over the cutouts on each of the outlet channels. 8 in. and 12 in. outlets are also available.

Use with Polydrain Channel 300. 6 in. (150 mm) outlet plates are made with a special adapter flume. Also available for PolyWall I and PolyWall II. Inlets / outlets available up to 12"

Use with Polydrain Channel 250. 6 in. (150 mm) outlet plates are made with a special adapter flume. Also available for PolyWall I and PolyWall II. Inlets / outlets available up to 12"

Use with Polydrain Channel 200. 6 in. (150 mm) outlet plates are made with a special adapter flume. Also available for PolyWall I and PolyWall II. Inlets / outlets available up to 12"

Use with Polydrain Channel 300. All 4 in. (100 mm) horizontal plates have inlet or outlet capability. As inlets, the upstream end of the following channel. All 4 in. (100 mm) plates are made with a PVC sleeve to accept either SCH40. Inlets / outlets...

Use with Polydrain Channel 250. All 4 in. (100 mm) horizontal plates have inlet or outlet capability. As inlets, the upstream end of the following channel. All 4 in. (100 mm) plates are made with a PVC sleeve to accept either SCH40. Inlets / outlets...

Use with Polydrain Channel 200. All 4 in. (100 mm) horizontal plates have inlet or outlet capability. As inlets, the upstream end of the following channel. All 4 in. (100 mm) plates are made with a PVC sleeve to accept either SCH40. Inlets / outlets...